Installing and initially configuring the application using the command line

You can install the Kaspersky Embedded Systems Security application on a client device using the command line.

Installation using the command line involves the following steps:

1. Installing the application and the graphical interface of the application. You can choose one of the following installation options:
   • Install the application with the graphical interface.
   • Install the application without the graphical interface.
   • Install the graphical interface on the device where the application is installed.

     It is not possible to install the graphical interface on a device on which the application is not installed.

   If the version of the apt package manager is lower than 1.1.X, use the dpkg/rpm package manager (depending on the operating system) for installation.

2. Initial configuration of the application

   The application needs initial configuration to prepare it for operation and enable the protection of the client device.

   If initial configuration of the application has not been completed on a device, you cannot use or update the application on that device.

   Initial configuration of the application is performed by running the special initial configuration script from the distribution kit of Kaspersky Embedded Systems Security. You can perform the initial configuration of the application in interactive mode or in automatic mode.

In this section Installing the application using the command line Post-installation configuration of the application in interactive mode Post-installation configuration of the application in automatic mode Settings in the configuration file for post-installation configuration

Page top