Contents
Configuring Network Threat Protection in the Administration Console
In the Administration Console, you can configure Network Threat Protection settings in the policy properties (Essential Threat Protection → Network Threat Protection).
Network Threat Protection component settings
Setting |
Description |
|---|---|
Enable Network Threat Protection |
This check box enables or disables Network Threat Protection. The check box is selected by default. |
Action on threat detection |
Actions performed upon detection of network activity that is typical of network attacks.
|
Block attacking devices |
This check box enables or disables the blocking of network activity when a network attack attempt is detected. The check box is selected by default. |
Block the attacking device for (min) |
In this field you can specify the duration an attacking device is blocked in minutes. After the specified time, Kaspersky Embedded Systems Security allows network activity from this device. Available values: integer from 1 to 32768. Default value: 60. |
Exclusions |
This group of settings contains the Configure button, which opens the Exclusions window, where you can specify a list of IP addresses. Network attacks from these IP addresses will not be blocked. |
Exclusions window
In this window, you can add IP addresses from which network attacks will not be blocked.
By default, the list is empty.
IP address window
In this window, you can add and edit IP addresses. Network attacks from these IP addresses will not be blocked by Kaspersky Embedded Systems Security.
IP addresses
Setting |
Description |
|---|---|
Enter an IP address |
Entry field for an IP address. You can specify IP addresses in IPv4 and IPv6 formats. |