About Integration Server Console
Integration Server Console is installed on a device with a Windows operating system and is launched using an executable file or via a link from the Kaspersky Security Center Administration Console (if installed on the same device).
The Integration Server Console contains the following sections:
- Integration Server settings
This section displays the following information:
- Version of the Integration Server with which the connection is established
- Name of the user account that was used to establish the connection to the Integration Server
- Type of authentication used when connecting to the Integration Server
- IP address in IPv4 format or the fully qualified domain name (FQDN) of the Integration Server
- Integration Server accounts
In this section, you can change the passwords of the internal Integration Server accounts used to connect management consoles, SVMs, and Light Agents to the Integration Server.
- List of connected SVMs
In this section, you can view information about SVMs that are connected to the Integration Server.
- SVM management
This section opens by default after the Integration Server Console is started. In this section, you can run the SVM Management Wizard that lets you perform the following actions:
- Deploy SVMs with the Protection Server component from an image in the virtual infrastructure.
- Reconfigure previously deployed SVMs.
- Remove SVMs.
- Infrastructure connection settings
In this section you can perform the following actions:
- View the status of the connection between the Integration Server and the virtual infrastructure.
- Change the Integration Server connection settings to the virtual infrastructure.
- If the Kaspersky Security solution is installed in VMware infrastructure, configure use of VMware NSX Manager in the operation of the solution.
- Remove the virtual infrastructure from the list of infrastructures to which the Integration Server connects.
- List of tenants
If you use the solution in multitenancy mode, in this section you can view a list of all tenants registered in the Integration Server database.
- Kaspersky Security Center connection settings
If you use the solution in multitenancy mode and the tenant protection infrastructure was deployed using the Integration Server's REST API, then in this section you can configure connection settings required for the Integration Server REST API to interact with the Kaspersky Security Center Administration Server.