Changing SVM IP settings

For this step, you can edit IP addressing settings used for all SVMs. You can use dynamic or static IP addressing.

To edit the IP address settings:

1. Select the Edit SVM IP settings check box.

   If you added virtual networks for one or more SVMs at the previous step of the Wizard, the Edit SVM IP settings check box is not displayed. You cannot proceed to the next step until the network settings of SVMs selected for reconfiguration have been configured.

2. If you want to specify all network settings of the SVM manually, select Static IP addressing. This opens a table containing the following information:
   • Hypervisor address

     IP address in IPv4 format or the fully qualified domain name (FQDN) of the hypervisor on which the SVM is deployed.

     The Hypervisor address column is displayed if the SVM is deployed in a virtual infrastructure based on Microsoft Hyper-V, XenServer, VMware vSphere, KVM, Proxmox VE, Basis, Skala-R, HUAWEI FusionSphere, Nutanix Acropolis, Alt Virtualization Server, Astra Linux, or Numa vServer.

   • OpenStack project name

     Name of the OpenStack project that the SVM is deployed in, as well as project path in the infrastructure.

     The OpenStack project name column is displayed if the SVM is deployed in a virtual infrastructure managed by the OpenStack platform, VK Cloud platform, or TIONIX Cloud Platform.

   • SVM name

     The name that was defined when specifying SVM settings.

   • Network name

     The name of the virtual network that the SVM uses to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

   Specify the following network settings for each SVM:

   • SVM IP address
   • Subnet mask
   • Gateway
   • DNS server
   • Alternative DNS
3. If you want to use DHCP network settings for all SVMs, select Dynamic IP addressing (DHCP).

   By default, the IP address of the DNS server and the IP address of the alternative DNS server received over the DHCP protocol are used for each SVM. If you specified several virtual networks for the SVM at the previous step, by default the network settings for the SVM are received from the DHCP server of the first virtual network in the list of the specified virtual networks.

   If you want to manually specify the IP address of the DNS server and alternative DNS server, clear the Use list of DNS servers received via DHCP check box. This opens a table containing the following information:

   • Hypervisor address

     IP address in IPv4 format or the fully qualified domain name (FQDN) of the hypervisor on which the SVM is deployed.

     The Hypervisor address column is displayed if the SVM is deployed in a virtual infrastructure based on Microsoft Hyper-V, XenServer, VMware vSphere, KVM, Proxmox VE, Basis, Skala-R, HUAWEI FusionSphere, Nutanix Acropolis, Alt Virtualization Server, Astra Linux, or Numa vServer.

   • OpenStack project name

     Name of the OpenStack project that the SVM is deployed in, as well as project path in the infrastructure.

     The OpenStack project name column is displayed if the SVM is deployed in a virtual infrastructure managed by the OpenStack platform, VK Cloud platform, or TIONIX Cloud Platform.

   • SVM name

     The name that was defined when specifying SVM settings.

   Specify the IP addresses of DNS servers in the DNS server and Alternative DNS server table columns.

Proceed to the next step of the wizard.

Page top