Editing SVM network settings

At this step, you can edit the network settings of the SVM.

Changing the list of networks on SVMs results in the creation of new network adapters. This could change the IP address of an SVM.

To change SVM network settings:

1. Select the Change SVM network settings check box.

   The window displays a table containing the following information about SVMs selected for reconfiguration:

   • Hypervisor address

     IP address in IPv4 format or the fully qualified domain name (FQDN) of the hypervisor on which the SVM is deployed.

     The Hypervisor address column is displayed if you are deploying the SVM to a virtual infrastructure based on Microsoft Hyper-V, XenServer, VMware vSphere, KVM, Proxmox VE, Basis, Skala-R, HUAWEI FusionSphere, Nutanix Acropolis, Alt Virtualization Server, Astra Linux, or Numa vServer.

   • OpenStack project name

     Name of the OpenStack project that the SVM is deployed in, as well as project path in the infrastructure.

     The OpenStack project name column is displayed if you are performing SVM deployment in a virtual infrastructure managed by the OpenStack platform, VK Cloud platform, or TIONIX Cloud Platform.

   • SVM name

     The name that was defined when specifying SVM settings.

2. For each SVM, specify one or more virtual networks in the Network name column.

   The name of the virtual network that the SVM will use to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

   You can specify one or more virtual networks. To add a field for selecting virtual networks, use the button located next to the network selection field.

   If you intend to use dynamic IP addressing (DHCP) for all SVMs, the network settings will be received from the DHCP server via the first virtual network in the list of networks specified for each SVM. Make sure that the Wizard can connect to the SVM with the network settings of the first virtual network received from the DHCP server.

   If the virtual infrastructure uses the VMware Distributed Virtual Switch component, you can specify a Distributed Virtual Port Group to which the SVM will be connected.

3. If you have selected to reconfigure SVMs deployed in a virtual infrastructure managed by the OpenStack platform, VK Cloud platform, or TIONIX Cloud Platform, you can also specify one or more security groups for each selected network in the Security group column.

   Set of network traffic filtering rules that are created in the virtual infrastructure and applied in the virtual network.

   The drop-down list displays all available security groups. You can specify one or more security groups for each selected virtual network. To select a security group, select the check box to the left of its name. The names of the selected security groups are displayed in the field.

4. If the SVMs that you selected for reconfiguration are deployed in a virtual infrastructure running the Microsoft Hyper-V platform, you can also specify the VLAN ID.

   The ID of the virtual local area network (VLAN) that the SVM will use to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

   If VLAN is not used, the column shows No.

Proceed to the next step of the wizard.