Kaspersky SD-WAN
Contents
Contents
Creating a service interface
To create a service interface:
- In the menu, go to the Infrastructure section.
The SD-WAN infrastructure management page is displayed. By default, the Network resources tab is selected, which displays the table of SD-WAN Controllers.
- Click Management next to the SD-WAN Controller and in the drop-down list, select Configuration menu.
This opens the SD-WAN Controller configuration menu. By default, you are taken to the Controller nodes section, which displays a table of Controller nodes.
- Go to the Service interfaces section.
A table of service and ACL interfaces is displayed.
- In the upper part of the page, in the Switch and Port drop-down lists, select a CPE device and an OpenFlow interface.
- Click Create service interface.
- This opens a window; in that window, in the Type drop-down list, select the type of encapsulation on the service interface:
- Access (selected by default).
- VLAN
- Q-in-Q.
- ACL — Used for creating an ACL interface.
- If in the Type drop-down list, you selected VLAN, in the VLAN ID field, enter the outer VLAN tag. Range of values: 1 to 4,094.
- If in the Type drop-down list, you selected Q-in-Q, follow these steps:
- In the VLAN ID field, enter the outer VLAN tag. Range of values: 1 to 4,094.
- In the Inner VLAN ID field, enter the inner VLAN tag. Range of values: 1 to 4,094.
- If necessary, enter a brief description of the service interface in the Description field.
- Click Create.
The service interface is created and displayed in the table.
Page top