You can view the table of multicast interfaces in a CPE template and on a CPE device:
To display the table of multicast interfaces in a CPE template, go to the SD-WAN → CPE templates menu section, click the CPE template, and select the Multicast → Interfaces tab.
To display the table of multicast interfaces on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, and select the Multicast → Interfaces tab.
Information about multicast interfaces is displayed in the following columns of the table:
Network interface is the network interface used as a multicast interface.
PIM indicates whether the exchange of messages with peers via the PIM protocol is enabled on the multicast interface:
Enabled
Disabled
IGMP indicates whether the exchange of messages with peers via the IGMP protocol is enabled on the multicast interface:
Enabled
Disabled
DR priority is the priority of the multicast interface. The highest-priority multicast interface becomes the designated router of the LAN segment. The greater the value, the higher the priority of the multicast interface.
Inherited indicates whether the multicast interface is inherited from CPE template:
Yes
No
This column is displayed only on the CPE device.
Management contains the actions that can be performed with the multicast interface.