Managing firewall templates

You can view the table of firewall templates in the SD-WAN →Firewall templates section. By default, the Default firewall template is created, which forms the basis for other firewall templates you create. Information about firewall templates is displayed in the following columns of the table:

• Name is the name of the firewall template.
• Usage specifies whether the CPE devices use the firewall template:
  • Yes.
  • No.
• Owner is the name of the user that created the firewall template.
• Last update is the date and time when the firewall template settings were last modified.

The actions that you can perform with the table are described in the Managing solution component tables article.

You can select an assigned firewall template to have it preselected when adding or manually registering a CPE device.

You can manage firewall template settings on the following tabs:

• General settings contains basic settings of the firewall.
• Rules contains firewall rules.
• NAT contains network address translation settings. The following tabs are displayed on this tab:
  • DNAT contains DNAT rules.
  • SNAT contains SNAT rules.
• Zone forwarding contains forwardings between firewall zones.
• IP address sets contains IP sets.

In this section Creating a firewall template Selecting an assigned firewall template Importing a firewall template Cloning a firewall template Viewing the usage of a firewall template Deleting a firewall template

Page top