Additional task settings
Show all | Hide all
On the Additional tab, you can configure advanced settings for the report generation task:
- Incident filtering by status
- The method of grouping incident information in the report
- Automatically sending a report to specified email addresses.
Include incidents with the following status in the report
The list of incident statuses selected for the report.
You can change the list of statuses based on which the application selects incidents for the report by clicking the Select button.
Sort data by columns
The list of incident details according to which incidents are arranged in the report table. The report starts with incidents for which the details specified in the field are the same.
You can change the order for grouping incidents with identical details by clicking the Select button.
The Email report list lets you select recipients to whom the application will automatically send the generated report.
To security officer
Automatically send the completed report to the email address of an information security specialist.
If this check box is selected, report sending is enabled. If this check box is cleared, report sending is disabled.
You can specify the email address of a security officer in the Data Leak Prevention node.
The check box is cleared by default.
Additionally
Automatically send the report to additional email addresses specified manually.
If this check box is selected, the application automatically sends the report to the email addresses specified in the entry field. Separate the email addresses with a semicolon.
If this check box is cleared, sending reports to additional addresses is disabled.
The check box is cleared by default.